ESP DIGI-VIEW 4 System Manual do Utilizador descarregar pdf (Página 10)

In the View Title, type Serial Terminal. In the Connection Type combo, select Serial. The Serial Port

must be configured with the device node into which the serial cable is plugged. Try with each one of the

serial ports detected before until the correct one is found. Do not change the other values (38400 baud, 8

data bits, 1 stop bit, no parity). Click OK to accept the configuration.

Once the serial port is configured, establish the connection by clicking the Connect/Disconnect button of

the Terminal view's toolbar.

In some Linux distributions, serial ports have restricted access. If the

serial port cannot be opened, its access permissions must be changed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sem comentários

ESP DIGI-VIEW 4 System Manual do Utilizador Página 10