ESP CanCam Manual de Instruções descarregar pdf (Página 12)

TV Out System Settings:

Press the [M] button once. •

The word “ tu ” on the camera’s internal screen will be blinking. •

Press the [OK] once and now you’ll see “ tu – n “ blinking.•

Press the [DN] button to set the camera’s TV OUT to PAL.•

The word “ tu – P ” will now be blinking. •

Press the [OK] to confirm this setting.•

The word “ tu - P “ will be blinking and then stops. •

Once the blinking stops, power off the camera. Wait for 5 seconds and then•

power up your camera again.

Advanced Instructions

There are 2 ways the camera can be programmed;

1. The camera unit can be programmed by using the pre-set mode:

PSET - This bypasses all user defined settings and uses the following

settings: (PIR mode / Resolution: 3MP / Burst: 3P / Time out: 30 seconds).

2. A fully user defined setting selection, which continues on the rest of the

manual’s pages.

CAM - This allows the user to define what setting the camera will use.

Camera Setup and Programming

When the camera switch is first turned to the CAM location, the internal LCD display

shows the camera status. The following information is present on this screen.

If no buttons are pressed after 30 seconds the LCD display will go into sleep mode

and the LCD display will switch to show the capture quality and enter a 1-minute

count down for the user to leave the capture area. The camera will then enter the

PIR detection mode or the Time lapse mode. To wake up the camera: press the UP

or DOWN button once, the LCD display will show the status of the camera.

Passive Infrared Mode Time-Lapse / PIR Mode

CanCam Manual_Layout 5 05/09/2013 12:22 Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

ESP CanCam Manual de Instruções Página 12